« Takaisin

PFM 97 ED

Jatkuvatoiminen pölyanalysaattori kosteille kaasuille, triboelektronisilla antureilla Fields of application
The dust concentration measuring device PFM 97 ED is used for the continuous extractive measurement of dust contents in wet and sticky exhaust gases.
By means of a temperature-regulated probe the measuring gas is extracted from the process and led to the measuring chamber where the triboelectric dust sensors are placed.
In order to produce evaluable measuring signals and to protect the triboelectric measuring cell respectively the gas lines of the measuring device the measuring gas sucked off is continuously heated and diluted with dry and dust-free ambient air. Ominaisuudet: The active principle of the dust measurement is based on the triboelectric effect. Therefore 2 electrically isolated half-shells are arranged in a cylindric chamber (measuring cell) and are passed by the conditioned measuring air. The triboelectric signals of the sensors are converted to equivalent dust signals in the electronic of the control unit
 
  • Special device consisting of probe and control unit
  • Extractive dust measurement in wet and sticky gases (Measurement of a diluted and heated partial flow)
  • Assembly:
    • Control unit: wall assembly or floor mounting / frame
    • Probe: special flange DN 80, PN 6, Di=100 mm
  • Analog outputs:
    • 4 ... 20 mA
  • Digital outputs (potential-free):
    • Limit value 1 (adjustable)
    • Limit value 2 (adjustable) / maintenance request
    • Failure
    • Maintenance
    • Measuring range (automatic measuring range change-over)

Tuote: pfm97ed

Suosittelemme myös

PMA 1000 V2.2

PMA1000.jpg&width=280&height=500
PMA 1000 V2.2 - M&C TechGroup
Paramagneettinen happianalysaattori
Tuote-esite:PMA 1000
Ominaisuudet:

Modulaarinen rakenne
7" kosketusnäyttö
Modbus TCP/IP ja AK protokolla TCP/IP
Ethernet/USB liitäntä
Painekompensaatio (0.6-1.6 bar abs.)
Dataloggaus
Optiona automaattinen kalibrointi..

Tuote: PMA1000

LaserGas III OP NH3

Lasergas_III_OP_NH3.jpg&width=280&height=500
LaserGas III OP NH3 on erityisesti suunniteltu mittaukseen ATEX alueille. Analysaattori koostuu lähettimestä ja vastaanottimesta jotka sijoitetaan vastakkain jopa 100 metrin päähän toisistaan. Lähettimen ja vastaanottimen välinen valo mittaa reaaliaikaisesti ammoniakin pitoisuutta koko matkalla ja muutokset..
Näytä kaikki vastaavat tuotteet »